| |
| Fishing & Marine Products By Barbare's Aluminum Foundry, Inc |
|
| RodTite Rod Holder, Cast Aluminum |
 RodTite Rod Holders designed and used by Striped Bass, Crappie and Catfish Fishermen Securely holds your expensive rod and reel Easy rod removal with big fish on Adjustable - Vertical tilt & Horizontal direction Rubberized coating, on our marine grade cast aluminum rod holder frame, prevents scratches and reduces noise Usable with most types of rod and reel combinations Fits any 1/2"-13nc base (not included) Included: One coated cast aluminum rod holder frame, one 1/2" x 4" SS stem bolt, one 1/2" SS flat washer, one 1/2" SS wing nut, one 1/2" SS nut. Assemble with ½” SS stem bolt (standard 4” long) through slot with head inside rod holder body, add SS flat washer and top SS wing nut with flat up toward rod holder body then add bottom SS standard nut, install stem in base, adjust, tighten and go fishing. Minimum mounting height above any flat deck should be greater than rod butt length for easy rod removal patent pending RodTite Rod Holder: $21.95/ea.plus shipping & handling
|
| RodTite 6" stem extender post |
6" stem extender post, includes 6" x 1/2" stainless steel threaded rod, 1" aluminum stiffener tube, stainless steel washer and 1/2" stainless steel coupler nut. (Base sold seperatly) |
| BLOW OUT SPECIAL |
BLOWOUT - Bundle of 4 - RodTite Rod Holders with 4 inch stems for $80.00Includes: (4) - RodTite Rod Holders with 4 inch stems as described above for $80.00. |
| Cleat-On Lantern Holder, Cast Aluminum |
 Made of marine grade cast aluminum Stainless Steel Hardware The versatile Cleat-On Lantern Holder installs quickly under many existing rope cleats, for night fishing, on boats, docks and piers. (no drilling required). Ready to use in seconds, Remove instantly after use. The adjustable lantern holder arm will raise and lower to suit your needs and locks into most boat, dock or pier cleats, with a center hole in the cleat, then raises, lowers and easily pops off after use. Cleat (not included), must have a center opening of no less than 1" wide and 1/2" high. Rubberized powder coated end to prevent scratches. Total extended length is approximately 24"
|
| RodTite T-Bar Bundle - T-Bar, 4 Rod Holders & Base |
 Includes: Four RodTite Rod Holders, with 4” stems One T-Bar, 1-1/2” x 1/2” x 24” aluminum bar drilled and tapped for 3 or 4 rod holders, 10” high, main stem. 1/2” stainless steel all thread rod 9(with a 10” x 1” aluminum outer stem for regidity) One surface mounted base.
- All Aluminum and Stainless Steel construction
- Fits many 1/2"-13nc bases
- Custom main stem lengths avaliable (contact us for more info)
$129.95 plus shipping & handling |
| RodTite Surface Mounted base |
 Aluminum Base, Surface Mounted for 1/2"-13nc rod holder stem, 1.5" x 2" x 1/2" thick. |
|
|
|
|
